DigitalVolcano Software Support

Up front: I know there is a restore to defaults for the entire Duplicate Cleaner.

After changing criteria in a scan mode (under 'Scan criteria'), e.g. Image mode, I would like to be able to 'reset' that mode to default.
AFAIK.. I can only do so by resetting DC as a whole(?)
IF so... then, as a positively meant suggestion, maybe add a 'Default' button in each mode.

Thanks.

There is the 'New scan' button on the home tab. This resets the scan modes and criteria to the default, but it will do all of them, not just one mode.
It's better than resetting the entire program, but perhaps a mode-by-mode default button is something for version 6.

Ah, right! Thank you very much.
I did not realize this. So, the other day I did a full reset.
Reason for my suggestion.
Anyway, thanks again.